Wire Drawing Dies

Product Details:

• Material: Made of cemented (sintered) tungsten carbide (WC), usually with a cobalt binder. Very hard, good wear resistance, quite tough. 
• Use‑case: Used for wire drawing, especially for wires or rods of moderate to large diameter, or when drawing harder/abrasive materials where diamond dies or PCD are too costly. Also good for short/medium run, trial runs.t/medium run, trial runs.

Product Details:

Here’s a detailed breakdown of 3 mm Wire  Drawing Dies for binding wire: what they are, key specs, materials, suppliers in India, cost‑considerations, etc. I can also pull up some specific product suggestions if you tell me the wire diameter, production scale, or budget.

Product Details:

• The 4 mm Wire Drawing Dies to a smaller diameter, hardened by drawing (cold working), and given a bright surface finish (often by passivation, cleaning, no coating, or polishing).
• The material is somewhat harder than mild steel in annealed condition, possibly more wear on dies, more stringent demands on die finish, lubrication, etc.

Product Details:

• High Precision Taper Design:Optimized entry, reduction, bearing, and back-relief zones ensure smooth wire flow, minimal friction, and accurate sizing.
• Superior Material Options:Tungsten Carbide Dies – Cost-effective and durable for ferrous and non-ferrous wire.
• Polycrystalline Diamond(PCD) Dies :Ideal for high-precision, high-speed, and non-ferrous applications.